The inspection of the fi rst manufactured parts is essential for the development of any manufacturing process. The prototypes are typically produced in small quantities and must be inspected against a blueprint... Read more

In casting and forging, raw parts are usually machined in some critical areas to obtain the final part. To make sure that the raw casting holds enough material to be machined, it is possible to carry out... Read more

Modelling of a lift system and performing finite element analysis to determine the deflection and stress/distortion of the various components of this mechanical assembly, for the company Nova Bus.

A number of fields require high-precision assemblies, including optics and photonics, electronics, and medicine. To ensure superior quality, Avestor turned to us to develop this dial measuring instrument developed for an electronics assembly line.

Well-designed fixtures make it possible to repeat the same assembly within desired tolerance levels. We created fixtures for Prévost Car that allow parts to pivot onto different sides during assembly. These designs also enable workers to sit or... Read more

Design and produce a test bench for measuring resistance to chainsaw cuts according to the applicable CSA standard. Based on detailed analysis of the standard, our team designed and managed the manufacture of this fully automated test bench... Read more

Our FEA, Ansys, helps us determine the load behaviour of many electrical component models. Our team frequently analyzes the following load cases: Climatic stress (wind, snow, ice, and dynamic loads); Static coefficient... Read more

Using Ansys software, Creaform can perform stress and distortion analyses for moving parts assemblies. This table makes it possible to raise aircraft components for easier assembly.